Honeywell LYNXR-2 Instrukcja Użytkownika Pobierz pdf (Strona 37)

– 37 –

USER FUNCTIONS

USER FUNCTIONSUSER FUNCTIONS

USER FUNCTIONS

Remote Phone Control Feature

Enter: (within eight seconds)

Your user code

Upon entering remote phone control mode the Lynx will announce “System, enter code”.

Remote Phone Control Commands

To remotely disarm system:

+ [1]

Your user code

To remotely arm in AWAY mode: + [2]

Your user code

To remotely arm in STAY mode: + [3]

Your user code

To remotely arm in AWAY or STAY mode with no delay: + [2] or [3] + [0]

Your user code

To remotely activate X10 devices 01-06: [#] + [4] + (2-digit) device no.

To remotely activate X10 devices 07 & 08: + [#] + [4] + (2-digit) device no.

Your user code

To remotely deactivate X10 devices 01-06: [#] + [7] + (2-digit) device no.

To remotely deactivate X10 devices 07 & 08: + [#] + [7] + (2-digit) device no.

Your user code

To remotely Bypass zones: + [6] + zone no.

Your user code

To remotely activate Forced Bypass: + [6] + [#]

Your user code

To remotely check system status: [✻]

To end remote phone session:

Hang Up or + [9]

Your user code

NOTES: (1) Check with your installer to see if the Forced Bypass mode has been enabled.

(2) When bypassing zones, make sure a confirmation beep sounds for each zone that has been

bypassed.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 63 64

Brak uwag

Honeywell LYNXR-2 Instrukcja Użytkownika Strona 37